NZXT Hades Manual do Utilizador

Hades User’s manual

NZXT. 8 3. Slide the 5.25” drive in from the front of the chassis Insert the 5.25” Device through the 5.25” bay 4. Match the holes with the bay and

NZXT. 9 5. Turn the screw less bracket to lock the drive. Attach the screwless bracket, then procee to turn and lock the device in place. User may

NZXT. 10 3. Slide the bracket back into the cage to secure it. Wire Routing and CPU fan bracket Removal The Hades is designed to allow for optimal

NZXT. 11 2. Use the opening at the top of the motherboard to route any 4pin or 8 pin cables to the motherboard 3. Remove heat sinks easily through

NZXT. 12 PSU filter removal In order to remove the filter for the power supply, please unscrew the four screws at the bottom of the chassis. D

NZXT. 13 Three Temperature LCD display The Hades three temperature display is mounted on the front panel and is designed to be viewed from a slightly

NZXT. 1 Thank you. Dear valued customers, Thank you for purchasing our product. We are thankful to all our fans for the continuing support, after jus

NZXT. 2 HADES Specifications Expansion galore: Nine 5.25” bay setup or Five 5.25“ and Four 3.5” Latest Hardware Support: VGA clearance room for 30

NZXT. 3 Rear, 1 x 120mm fan (Included) Side, 1 x 200mm fan (Included) Top, 2 x 120/140mm fan (1 x 140 included) CHASSIS DIMENSIONS (D x W x H): 525 x

NZXT. 4 1. Remove the thumb screws securing the side panels. 2. Pull the side panel back, and then lift the panel to remove it. Motherb

NZXT. 5 1. Match the motherboard form factor ( ATX, M-ATX, ITX ) with the holes on the motherboard tray 2. Secure the standoffs onto the holes which

NZXT. 6 USB Installation 1. The USB is located of the top on your front panel. 2. Refer to your motherboard manual and match the labels on the USB

NZXT. 7 External 5.25” / 3.5” Drive Bay Installation Please follow the directions below to install the 5.25” in the Hades chassis, follow the same in